Insight turns your agency's PolarHub API usage into AI-generated reports that help you improve your L2B (Look-to-Book) numbers — and then prove whether your changes worked. Instead of crunching data yourself, you get clear recommendations on which routes to block and a before/after read on the impact once you do.Insight is available in the Production environment only, because the source data the analysis relies on lives exclusively in Production.
View the list of Insight reports you have requested
L2B Strategy report
Answers "Which routes should I control?" It analyzes your L2B metrics and revenue to recommend routes to block, along with the expected impact.L2B Result report
Answers "How did the block actually work out?" It compares the before-and-after data for the route controls you set up so you can see the real improvement.Step 1: Create a Strategy report and block routes#
Generate an AI strategy report, review its findings, then act on its recommendations — all without leaving Insight. Recommended routes flow straight into Airline Route Control, so a strategy report can directly drive your route blocking.Click [View Insights] in the Dashboard widget.
Once generated, view the Insights Report.
Insight report showing the Report Content analysis and the Action Panel with recommended routes
1
Request the report
In the L2B Alert or L2B Insights widget on the dashboard, click View Insights.
The AI starts analyzing your data in real time (typically around 2 minutes).
2
Review the analysis
In the Report Content section, see — per airline — which routes have poor L2B metrics, why, and a simulation of what blocking each route would do (such as the revenue impact).
3
Block the recommended routes
The Action Panel section at the bottom of the report lists the routes the AI recommends.
Enter a block period and click Create. You can create several routes at once in a single batch.
Once a route is created, click View to jump straight to its route control detail page.
Reference: report status#
Report generation can take a while depending on how much data there is. The screen reflects the current status:| Status | What you see and what to do |
|---|
| PENDING | A "Generating report" loading screen appears. It usually takes around 2 minutes. Don't refresh — it appears automatically when it's done. You're welcome to navigate away and come back. |
| SUCCESS | Analysis is complete and the report body appears. |
| FAIL | Report generation failed. Click Retry to request it again. |
Data timing: Reports are built from data aggregated by day, so today's traffic shows up starting with tomorrow's report.
Find past reports: Every report you've generated lives under Report > Insights. Filter by airline or period to review your earlier strategies.
Reuse existing reports: If a report already exists for the same conditions, you can open it right away instead of waiting for a new one.
Step 2: View the Result report#
Once your route blocks have been running, the Result report shows you whether they paid off.1
Open the report
On the Aggregator > Airline Route Control detail page, click Mid-term Report (in progress) or Final Report (completed).
If you received a report notification email, use the link inside it to reach the Airline Route Control detail page.
2
Compare the improvement
The report shows the analysis period (when the block was active) side by side with the comparison period (before the block).
See at a glance how much your L2B metrics stabilized and how many Look calls you saved.
